broadcasting microphone sound mixer software

Broadcasting microphone sound mixer software how to#
Broadcasting microphone sound mixer software install#
Broadcasting microphone sound mixer software download#

The lower the better for short audio signals like drums, single claps etc. Pre-comp : In ms, can be set so that the compression starts by the amount before the input signal reaches over the threshold.Īttack: In ms, determines how fast the compressor starts to work. 2:1 = For every 2 dB of the input signal that is over the threshold, only 1 dB will reach the output. Ratio : Determines by how much the signals that are over the threshold will be reduced. If set too low, you might end up increasing the noise. The more dynamic your audio signal has (for example switching between normal talking and loud screams), the lower you might want to set the threshold down to -20 and below. For a calm voice-over or commentary usually between -4 and -6 is a good starting point. Threshold: In dB, is the audio level where the compressor will start to work. Let’s define what each of these settings mean, and how it affects your sound.

Broadcasting microphone sound mixer software how to#

If you have the knowledge, you’ll probably figure out how to use this tool better than I do. For the fellow newbies, I’m going to break down this tool enough for you to get a sufficient compressor working. Now, let me remind you, I’m an audio noob. So if you are looking for somewhere to start, this will give you some idea.

The picture above shows my current compressor settings.

Make sure you’ve changed your microphone output to Voicemeeter Output on whatever program you use for testing, otherwise your friend won’t hear the changes! I recommend getting a friend to listen over a voice communication program to help you easily test out the settings.

This is where you will configure and fine tune your compressor settings. Connect the left yellow node to the top left yellow dot on the program, and the right yellow dot to the right yellow node as pictured below.This guide uses reacomp, but for advanced users feel free to check out reaxcomp. Note: There is another plugin called reaxcomp-standalone. Right click somewhere in the middle of the program -> Add Plugin -> reacomp-standalone Back on the preferences page, make sure the ‘Audio device type’ is set to ASIO and your ‘device’ is Voicemeeter Insert Virtual ASIO.

Scan and verify to add the Reaper ReaPlugs plugins into the program.

Minihost Modular: File -> Preferences -> Plugins.

At the bottom where it says ‘Patch Insert’, make sure “in1 Left” and “in1 Right” are turned on by simply clicking on the boxes.

In Voicemeeter Banana: Menu -> System Settings/Options.

Broadcasting microphone sound mixer software install#

Install Minihost Modular and Reaper ReaPlugs.

Setup Voicemeeter Banana using Rhinehold’s guide.

Hopefully this guide can help others improve their audio quality in their stream with some awesome free software! I needed something a bit more advanced but nothing overly complicated I am far from being an audio expert. The higher I raised the compressor, the more background noise was being picked up and my voice quality decreased. However, I found the compressor tool for Voicemeeter Banana to be a bit lackluster for my needs. The main reason I decided to get a virtual audio mixer was to properly setup a compressor for my Razer Seiren microphone (USB). Make sure to check that out for setting up Voicemeeter Banana, an awesome virtual mixer. This guide is an expansion of Rhinehold’s Voicemeeter Banana setup guide.

Broadcasting microphone sound mixer software download#

Minihost Modular (Free) – You’ll have to register for an account to see the download link in the forums.